2nd Light Forums |
Topic Title: sun cure epoxy Topic Summary: thin coat not kicking? Created On: 01/03/2023 02:32 AM |
Linear : Threading : Single : Branch |
- tom | - 01/03/2023 02:32 AM |
- dingpatch | - 01/03/2023 03:36 AM |
- tom | - 01/03/2023 05:54 AM |
- JOESTRUMMER | - 01/03/2023 07:44 AM |
- waterlizard25 | - 01/04/2023 07:39 AM |
- tom | - 01/06/2023 02:48 AM |
- Cole | - 01/07/2023 08:17 PM |
- StirfryMcflurry | - 01/08/2023 10:53 AM |
- tom | - 01/08/2023 11:19 AM |
- Cole | - 01/09/2023 06:32 AM |
- tom | - 01/10/2023 05:32 AM |
- waterlizard25 | - 01/11/2023 01:32 PM |
- JOESTRUMMER | - 01/11/2023 10:23 PM |
- Cole | - 01/12/2023 07:07 AM |
- StirfryMcflurry | - 01/12/2023 10:19 AM |
- waterlizard25 | - 01/12/2023 02:00 PM |
- JOESTRUMMER | - 01/12/2023 03:40 PM |
- StirfryMcflurry | - 01/12/2023 04:01 PM |
- Cole | - 01/13/2023 09:42 AM |
- StirfryMcflurry | - 01/13/2023 11:07 AM |
- Cole | - 01/13/2023 09:41 AM |
- oipaul | - 01/03/2023 08:41 AM |
- CurtisEflush | - 01/03/2023 11:51 AM |
- Cole | - 01/03/2023 03:08 PM |
- LBLarry | - 01/06/2023 02:58 PM |
- fredman | - 01/06/2023 06:10 PM |
- CurtisEflush | - 01/11/2023 08:22 AM |
Topic Tools
|
01/03/2023 03:08 PM
|
|
Epoxy won't kick at all if the temperature is under 55 degrees, but your bead kicked, so that rules out too cold, and too old. It has to be an outside issue like water, as mentioned, or oils entrenched into the board itself, and perhaps a bad mix. If the stuff is still good, let the crack dry, rough it up to remove any oils and then apply.
I used to cheat some of these with Suncure poly. Sand it, remove the splintered glass, fill with Elmer's (a buffer between polystyrene foam and polyester resin), let glue dry, then coat with Suncure. ------------------------- I was right. Edited: 01/03/2023 at 03:10 PM by Cole |
|
|
|
FORUMS
:
Surfing
:
sun cure epoxy
|
Topic Tools
|
FuseTalk Basic Edition - © 1999-2024 FuseTalk Inc. All rights reserved.
First there was Air Jordan .