What a cool board.

-------------------------

"One of the reasons why propaganda tries to get you to hate government is because it's the one existing institution in which people can participate to some extent and constrain tyrannical unaccountable power." Noam Chomsky.

is the tat thickness measurement right? 1 3/4?

Ok, I'm busted. All dims done with eyeball and tape rule. I went and checked a board that I know is 2 1/4 for comparison and it looked like 2 to me. So yes, I believe this is probably closer to 2 than 1 3/4". I'll try to find somebody with calipers who can actually measure it. Sorry! Um, you don't have any calipers do ya?

-------------------------
add a signature since I'm here in profile anyway

Ok used the level method: fins out, flat on the driveway, bubble level on the stringer. I get 2 1/4 on one side and 2 1/8 on the other so, 2+ a little" thickness. Checked with a 2x4 and got 1 1/2 and 1 5/8 on either side so think this is pretty close. Again, sorry for the bad info.

-------------------------
add a signature since I'm here in profile anyway

Edited: 12/21/2020 at 08:27 AM by tom

Hey Tom, I think that was probably 2 1/4 or 2 3/8. (My guess is closer to 2 3/8). (Dude who sold you the board).

Thanks Fred! I couldn't remember who I got it from, sorry. Thanks for the board, it's been really fun. BTW - dims are on the bottom but width is totally illegible, just a squiggle.

-------------------------
add a signature since I'm here in profile anyway

That sounds right, and what I was thinking...... 1 3/4" would prob scare away most potential buyers Poly blank with an epoxy lam job...... that puppy should last quite some time.

Edited: 12/22/2020 at 05:15 AM by Plan B

Bump

-------------------------
add a signature since I'm here in profile anyway

Edited: 02/13/2021 at 02:37 AM by tom